M-005 Dual Channel Parallel Injection - LEAP Shell "(M-Fab)"

From LEAP

Revision as of 19:12, 23 April 2009 (view source) Bpeat (Talk | contribs) (→Contact LEAP) ← Older edit		Revision as of 23:32, 28 April 2009 (view source) Bpeat (Talk | contribs) Newer edit →
Line 30:		Line 30:
	[[Image:Valve_Drawing_Dual_Stream_1.png]]		[[Image:Valve_Drawing_Dual_Stream_1.png]]
-	----	+	-----
		+	[[Image:LEAP Logo.png|frame|www.leaptec.com<br>www.leapwiki.com]]
		+
	=== Contact LEAP ===		=== Contact LEAP ===
Line 38:		Line 40:
-		+	<br><br>
-	Keyword: LEAP Shell Software, M-Fab, PAL, 10 port valve, selector valve, injector valve, gradient pump, regeneration pump,front cut,back cut, peaks of interest, single sample list, staggering injection, 2 channel, acquisition, Analyst SOftware	+	[[Category:LEAP Shell]]

---

Revision as of 23:32, 28 April 2009

	Dual Channel Parallel Injections with LEAP Shell "M-Fab"
	Application Type
	SPECIAL
	Application ID
	M-005
	Description
	High Throughput LC injections alternating onto two analytical columns.

Overview

• LEAP Shell - M-Fab application integrated with Analyst with supported pumps.

If the peaks of interest come off together in the middle of the gradient (as shown below) then it is possible to utilize the front cut and back cut time to increase throughput.

If injections are staggered in the following way, there is a potential for up to 100% gain:

Hardware Requirements

• TrioVS multiple valve system is required in addition to the standard injection valve.

---

Contact LEAP

For additional information about this technique please contact LEAP Technologies for detailed information

• Contact the LEAP office