M-005 Dual Channel Parallel Injection - LEAP Shell "(M-Fab)"
From LEAP
(Difference between revisions)
(→Contact LEAP) |
(→Contact LEAP) |
||
| Line 30: | Line 30: | ||
[[Image:Valve_Drawing_Dual_Stream_1.png]] | [[Image:Valve_Drawing_Dual_Stream_1.png]] | ||
| + | ---- | ||
=== Contact LEAP === | === Contact LEAP === | ||
Revision as of 19:12, 23 April 2009
| Dual Channel Parallel Injections with LEAP Shell "M-Fab" |
| Application Type | |
| SPECIAL | |
| Application ID | |
| M-005 | |
| Description | |
| High Throughput LC injections alternating onto two analytical columns. |
Overview
- LEAP Shell - M-Fab application integrated with Analyst with supported pumps.
If the peaks of interest come off together in the middle of the gradient (as shown below) then it is possible to utilize the front cut and back cut time to increase throughput.
If injections are staggered in the following way, there is a potential for up to 100% gain:
Hardware Requirements
- TrioVS multiple valve system is required in addition to the standard injection valve.
Contact LEAP
For additional information about this technique please contact LEAP Technologies for detailed information
Keyword: LEAP Shell Software, M-Fab, PAL, 10 port valve, selector valve, injector valve, gradient pump, regeneration pump,front cut,back cut, peaks of interest, single sample list, staggering injection, 2 channel, acquisition, Analyst SOftware
